The circuit board has three anti-treatment and layered structure design, even if a small amount of water enters, it will not damage the equipment.
Standard RS485 communication, short-range wireless RF optional.
The injection molding process is adopted at the terminal, and the phenomenon of short circuit and wire contact does not occur, making it easier for the customer to operate.
Battery reversal will automatically alert you
The battery input end will not be damaged continuously, and there will be a buzzer warning. It avoids damage to the equipment due to wiring errors, fires, and better protects the battery.
Continuous short-circuit output protection
The discharge output has continuous short-circuit output protection and over-current protection. Recover yourself after abnormal exclusion. It avoids damage to the equipment due to malfunction of the electrical equipment (especially short circuit) or causes fire.
Fan speed steady power generation control technology
The fan steady-speed power generation control method can make the fan not run at super-speed. In strong winds, the fan can control continuous power generation at a set speed to avoid direct braking of the fan due to stall caused by strong wind. Greatly increase the power generation of the fan and keep the fan running normally.
Wind stall current limiting power generation control technology
The fan stall limiting current control method can prevent the fan from running under overcurrent and protect the expensive generator from being damaged by the heat generated by the overcurrent.
Wind Turbine Input MPPT Power Generation Technology (Buck)
The wind-solar complementary controller can provide a 15-segment matching curve input configuration mode (input speed vs. input current; or input voltage vs. input current curve), which can greatly reduce the wind turbine’s low wind speed and generate electricity efficiently.
Support for multiple output mode selections
The controller offers a variety of output modes (light control, time control, morning light, PWM dimming, reverse) for easy application.
Statistics on cumulative power generation, remaining power, speed, current, temperature, etc.
The controller screen has conventional wind turbines, unloading, current, voltage and power display at the output, as well as the cumulative power generation display of the wind turbine, power display, wind turbine speed and unloading current display. The temperature of the controller is displayed.
The controller wiring terminal is placed with the warning function facing up
When the wind turbine controller terminal is placed upwards, it will be pre-warned to allow the customer to use it in the correct installation direction, avoiding the use in the open air, or due to weather, the surface of the wire is dew, and the rain directly along the wire, the water is introduced into Inside the controller, the possibility of damaging the controller after a large amount of water accumulates.